Sleeping Beauty

Bare Bone V3

 An Atmega1284P board made of all Through Hole parts

Sleeping Beauty Bare Bone board V3 Features:

  • DIP socket for the 1284P or the 328P, easy to change from one to another.
  • Bootloader for the 1284P customized by Roger Schaefer (flashes D13) from Mighty1284 Optibootloader (flashes D4), that's the only change, compatible with Arduino bootloader.
  • All parts are through hole parts, easy for DIY, and the FT231XS is replaced by the popular FTDI cable
  • Socketed 16 MHz Crystal, easy to change to a different frequency, 8 MHz or 20 MHz, without soldering
  • Auto reset, enabled / disabled by a jumper
  • nRF24L01+ connector
  • Buffed D13 LED by the 2N7000 MOSFET
  • Ground post for scope
  • Standard Arduino UNO R3 form factor and fits the UNO enclosure
  • License free if you make and sell it commercially .
  • No warranty, either express or implied, is given for the PCB.  Agree our terms before buying the PCB. No alteration on silkscreens. We shall not be liable for any claims, expenses, damages, and loss of profits, opportunities or information arising from the use of this PCB.

Sleeping Beauty-BB-V3

with nRF24L01+ installed


The above V3 bare PCB is available at OSHpark: https://www.oshpark.com/shared_projects/i3RY5IrZ

Schematic and BOM are available at Roger's web site:  http://www.rasmicro.com/Sleeping_Beauty/



Arduino UNO is a registered trademark of Arduino, LLC.